Diagnostic Test

CHECK FOR AN ACTIVE DTC

NOTE:

This DTC must be active for the results of this test to be valid. Check for a loose scan tool connection. Verify battery charger is installed and charge rate provides approximately 13.5 volts.

Turn the ignition on.
With the scan tool, read DTCs and record on vehicle work order.
With the scan tool, erase DTCs.
With the scan tool, read EPS DTCs.
Is the DTC active?

Yes
- Replace the Electric Power Steering (EPS) Module in accordance with the Service Information. Refer to GEAR, REMOVAL AND GEAR, INSTALLATION .
- Perform EPS VERIFICATION TEST. Refer to: : EPS VERIFICATION TEST .
No
- Test complete. The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform EPS VERIFICATION TEST. Refer to: : EPS VERIFICATION TEST .