Brake System Control Module

REMOVAL 

1. Remove the left front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
2. Disconnect the Brake System Control Module (BSCM) wire harness connector.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Wire Harness Connector

3. Remove and DISCARD  the Brake System Control Module (BSCM) bolts.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Brake System Control Module (BSCM) Bolts

4. Remove the BSCM.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

• Install NEW  Brake System Control Module (BSCM) bolts and tighten in sequence as shown in the illustration.
• Connect the scan tool and initialize the BSCM by performing the BSCM Verification Test. Refer to BSCM VERIFICATION TEST .