Body Control Module (BCM)

REMOVAL 

1. Disconnect the negative battery cable.
2. Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
3. Disconnect the wire harness connectors from the BCM.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Wire Harness Connector

   2 - BCM

4. Remove the fasteners that secure the BCM and bracket to the instrument panel.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Fasteners

   2 - BCM

5. Lower the BCM and bracket from the instrument panel.

   Courtesy of CHRYSLER GROUP, LLC

   1 - BCM

   2 - Wire Harness Connectors

6. Disconnect the wire harness connectors on the backside of the BCM.
7. Remove the BCM from the vehicle.
8. If necessary, remove the BCM from the BCM bracket.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

• Tighten the fasteners securely.