LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2024 >> ProMaster 2500 Base >> Repair and Diagnosis (Single Page) >> Restraints >> Restraints Control Systems >> Occupant Restraint Controller (Orc) - DTCS U0155-00 To U1930-86 >> DTC Troubleshooting >> U0422-00 Body Control Module BCM - Implausible Data Received >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. TEST FOR POOR CONNECTIONS OR INTERMITTENT CONDITIONS 
    1. Turn the ignition on.
    2. With the scan tool, generate and record the Vehicle Scan Report.
    3. With the scan tool, erase DTCs.
    4. Turn the ignition off.
    5. Wait for 10 seconds.
    6. Turn the ignition on and start the engine.
    7. Operate the vehicle in the conditions that set this DTC.
    8. With the scan tool, read Power LiftGate Module (PLGM) DTCs.

      Did the DTC return?

      Yes 

      • Go to  2

      No 

      • The conditions that originally set this DTC are not present in the moment. Refer to the Wiring Information and check all related connectors for signs of water intrusion, corrosion, bent or spaced connectors and proper pin voltage. If no problem is found, the test is complete. Perform the TESTING FOR AN INTERMITTENT CONDITION. Refer to TESTING FOR AN INTERMITTENT CONDITION .
  2. CHECK FOR ACTIVE BODY CONTROL MODULE (BCM) DTCS 
    1. With the Scan tool, read Body Control Module (BCM) DTCs.

      Is there any problem?

      Yes 

      • Repair all Body Control Module (BCM) active DTCs.

      No 

      • Go to  3
  3. CHECK THE POWER LIFTGATE MODULE (PLGM) HARNESS CONNECTIONS 
    1. Disconnect all Power LiftGate Module (PLGM) harness connectors.
    2. Disconnect all related in-line harness connectors (if equipped).
    3. Disconnect all related systems harness connectors.
    4. Check the harness and components connectors and the male female terminals for the following conditions
      • Proper connector installation.
      • Apparently damaged connectors lock.
      • Corrosion.
      • Water contact signs.
      • If the weatherproof protection is damaged (If equipped).
      • Bent terminals.
      • Overheating due to poor connection (terminal should be colorless due to overheat).
      • Terminals that have been damaged due to being pushed.
      • Perform a terminal drag test on each terminal to verify proper terminal tension.
    5. Repair any damage found on step 4.
    6. Reconnect all Power LiftGate Module (PLGM) harness connectors. Make sure all the connectors are fully seated and the connector locks are fully engaged.
    7. Reconnect all the in-line harness connectors (if equipped). Make sure all the connectors are fully seated and the connector locks are fully engaged.
    8. Reconnect all the harness related connectors. Make sure the connectors are fully seated.
    9. With the scan tool, erase all DTCs.
    10. Operate the vehicle in the conditions that set this DTC.
    11. With the scan tool, read the Power LiftGate Module (PLGM) DTCs.

      Did the DTC return?

      Yes 

      • IF THE PROBLEM PERSISTS, CONTACT FCA SPECIALIZED SUPPORT.

      No 

      • TEST COMPLETE.
scientia non olet · About LEMON Manuals