LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2024 >> ProMaster 2500 Base >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Electronic Control Modules (Service Information) >> Standard Procedure >> Module Replacement And Programming Order Guide
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module Replacement And Programming Order Guide

The Immobilizer Component Replacement guide has been modified to list all of the Immobilizer related procedures, found in wiTECH, listed by priority. Starting with the most important procedure first, along with an "X" to indicate when it is necessary to run this procedure.

Priority Procedure Name BCM ECM ESL FOBIKs RF-HUB
1 Restore Vehicle Configuration X - - - -
2 RF-Hub Replacement - - - - X
3 Disable FOBIKs - - - - X
4 Enable FOBIKs - - - X -
5 BCM replacement X - - - -
6 Transfer Secret Key To ESL ECM - X X - -
7 PROXI Alignment X X X - X
8 ECU Specific Procedures X X X - X
COMPONENT MODULE REPLACEMENT GUIDE (BCM, Keys, ESL, PCM, RF-Hub)
  Condition 1 Condition 2 Condition 3 Condition 4 Condition 5 Condition 6 Condition 7 Condition 8 Condition 9 Condition 10 Condition 11 Condition 12 Condition 13 Condition 14
RF-Hub New New Existing Existing Existing Existing New New New New Existing Existing Existing New
FOBIKs (RKE Only) Existing New New Existing Existing Existing New Existing Existing Existing Existing Existing Existing New
BCM Existing New Existing New Existing Existing Existing New Existing Existing New New Existing New
PCM Existing New Existing Existing New Existing Existing Existing New Existing New Existing New New
ESL Existing Existing Existing Existing Existing New Existing Existing Existing New Existing New New New
PROGRAMMING ORDER ASSOCIATED MODULE MISC. FUNCTION
1 RF-Hub replacement Perform the Vehicle Restore Configuration Enable KEYs/FOBIKs (Only the new FOBIK needs to be present, previously stored FOBIKs will remain enabled.) Perform the Vehicle Restore Configuration Flash the ECM/PCM if the Spare Part is supplied without software Transfer secret key to ESL / ECM RF-Hub replacement Perform the Vehicle Restore Configuration RF-Hub replacement RF-Hub replacement Perform the Vehicle Restore Configuration Perform the Vehicle Restore Configuration Flash the ECM/PCM if the Spare Part is supplied without software Perform the Vehicle Restore Configuration
2 Disable KEYs/FOBIKs (Only if the procedure did not run automatically after the RF-Hub replacement procedure. All FOBIKs should be present, but the FOBIKs not present at this time will be temporarily disabled. It will be possible to re-enable them by running the Enable KEYs/FOBIKs procedure.) RF-Hub replacement ---- BCM replacement Control unit replacement (If available will be found in the ECM ECU.) PROXI alignment procedure Disable KEYs/FOBIKs ONLY using the already stored FOBIKs (Only if the procedure do not run automatically after the RF-Hub replacement procedure. The FOBIKs not present at this time will be temporarily disabled but will be possible to re-enable them running the Enable KEYs/FOBIKs procedure) BCM replacement (first phase, at a certain point will be asked to configure the RF-Hub, at that point run the RF-Hub replacement, after the RF-Hub replacement and the Disable Fobiks procedures run again the BCM replacemnt procedure in order to complete the BCM configuration) Disable KEYs/FOBIKs (Only if the procedure do not run automatically after the RF-Hub replacement procedure. The FOBIKs not present at this time will be temporarily disabled but will be possible to re-enable them running the Enable KEYs/FOBIKs procedure) Disable KEYs/FOBIKs (Only if the procedure do not run automatically after the RF-Hub replacement procedure. The FOBIKs not present at this time will be temporarily disabled but will be possible to re-enable them running the Enable KEYs/FOBIKs procedure) BCM replacement BCM replacement Control unit replacement (If available will be found in the ECM ECU.) RF-Hub replacement
3 RF-Hub_TPM Update FF_FR Axle Nom Tire Press Val (only if the vehicle is equipped with TPM sensors, or if the current pressure value set by the RF-Hub replacement routine is different from the expected due to aftermarket tire size on the vehicle.) Disable KEYs/FOBIKs ONLY using the already stored FOBIKs (Only if the procedure do not run automatically after the RF-Hub replacement procedure. The FOBIKs not present at this time will be temporarily disabled but will be possible to re-enable them running the Enable KEYs/FOBIKs procedure) ---- Run BCM ECU Reset (Found under the Diagnostic Procedures Tab of the Vehicle View screen) Transfer secret key to ESL / ECM (only if the Control unit replacement procedure was not available in previous step.) ---- Enable KEYs/FOBIKs ONLY using the new FOBIK(s) and eventually FOBIKs not presented during the Disable KEYs/FOBIKs procedure (Only the new or previously disabled FOBIK needs to be present, previously stored FOBIKs will remain enabled.) RF-Hub replacement Flash the ECM/PCM if the Spare Part is supplied without software Transfer secret key to ESL / ECM Run BCM ECU Reset (Found under the Diagnostic Procedures Tab of the Vehicle View screen) Run BCM ECU Reset (Found under the Diagnostic Procedures Tab of the Vehicle View screen) Transfer secret key to ESL / ECM (only if the Control unit replacement procedure was not available in previous step.) Disable KEYs/FOBIKs ONLY using the already stored FOBIKs (Only if the procedure do not run automatically after the RF-Hub replacement procedure. The FOBIKs not present at this time will be temporarily disabled but will be possible to re-enable them running the Enable KEYs/FOBIKs procedure)
4 Program Left Front Tire Sensor ID, Program Left Rear Tire Sensor ID, Program Right Front Tire Sensor ID, and Program Right Rear Tire Sensor ID Enable KEYs/FOBIKs ONLY using the new FOBIK(s) and eventually FOBIKs not presented during the Disable KEYs/FOBIKs procedure (Only the new or previously disabled FOBIK needs to be present, previously stored FOBIKs will remain enabled.) ---- ---- PROXI alignment procedure(only if the Control unit replacement procedure was not available in previous step.) ---- ---- Disable KEYs/FOBIKs (Only if the procedure do not run automatically after the RF-Hub replacement procedure. The FOBIKs not present at this time will be temporarily disabled but will be possible to re-enable them running the Enable KEYs/FOBIKs procedure) Control unit replacement (If available will be found in the ECM ECU.) PROXI alignment procedure Flash the ECM/PCM if the Spare Part is supplied without software Transfer secret key to ESL / ECM PROXI alignment procedure(only if the Control unit replacement procedure was not available in previous step.) Enable KEYs/FOBIKs ONLY using the new FOBIK(s) and eventually FOBIKs not presented during the Disable KEYs/FOBIKs procedure (Only the new or previously disabled FOBIK needs to be present, previously stored FOBIKs will remain enabled.)
5 ---- BCM replacement ---- ---- ---- ---- ---- BCM replacement (second phase, in order to complete the BCM configuration) Transfer secret key to ESL / ECM (only if the Control unit replacement procedure was not available in previous step.) RF-Hub_TPM Update FF_FR Axle Nom Tire Press Val (only if the vehicle is equipped with TPM sensors, or if the current pressure value set by the RF-Hub replacement routine is different from the expected due to aftermarket tire size on the vehicle.) Control unit replacement (If available will be found in the ECM ECU.) PROXI alignment procedure ---- BCM replacement
6 ---- Run BCM ECU Reset (Found under the Diagnostic Procedures Tab of the Vehicle View screen) ---- ---- ---- ---- ---- RF-Hub_TPM Update FF_FR Axle Nom Tire Press Val (only if the vehicle is equipped with TPM sensors, or if the current pressure value set by the RF-Hub replacement routine is different from the expected due to aftermarket tire size on the vehicle.) PROXI alignment procedure(only if the Control unit replacement procedure was not available in previous step.) Program Left Front Tire Sensor ID, Program Left Rear Tire Sensor ID, Program Right Front Tire Sensor ID, and Program Right Rear Tire Sensor ID Transfer secret key to ESL / ECM (only if the Control unit replacement procedure was not available in previous step.) ---- ---- Run BCM ECU Reset (Found under the Diagnostic Procedures Tab of the Vehicle View screen)
7 ---- Flash the ECM/PCM if the Spare Part is supplied without software ---- ---- ---- ---- ---- Program Left Front Tire Sensor ID, Program Left Rear Tire Sensor ID, Program Right Front Tire Sensor ID, and Program Right Rear Tire Sensor ID ---- ---- PROXI alignment procedure(only if the Control unit replacement procedure was not available in previous step.) ---- ---- Flash the ECM/PCM if the Spare Part is supplied without software
8 ---- Control unit replacement (If available will be found in the ECM ECU.) ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- Control unit replacement (If available will be found in the ECM ECU.)
9 ---- PROXI alignment procedure(only if the Control unit replacement procedure was not available in previous step.) ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- Transfer secret key to ESL / ECM (only if the Control unit replacement procedure was not available in previous step.)
10 ---- RF-Hub_TPM Update FF_FR Axle Nom Tire Press Val (only if the vehicle is equipped with TPM sensors, or if the current pressure value set by the RF-Hub replacement routine is different from the expected due to aftermarket tire size on the vehicle.) ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- PROXI alignment procedure(only if the Control unit replacement procedure was not available in previous step.)
11 ---- Program Left Front Tire Sensor ID, Program Left Rear Tire Sensor ID, Program Right Front Tire Sensor ID, and Program Right Rear Tire Sensor ID ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- RF-Hub_TPM Update FF_FR Axle Nom Tire Press Val (only if the vehicle is equipped with TPM sensors, or if the current pressure value set by the RF-Hub replacement routine is different from the expected due to aftermarket tire size on the vehicle.)
12 ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- Program Left Front Tire Sensor ID, Program Left Rear Tire Sensor ID, Program Right Front Tire Sensor ID, and Program Right Rear Tire Sensor ID
scientia non olet · About LEMON Manuals