Installation

1. Attach hoist and lower engine into engine compartment.
2. Align engine mounts and install all nuts. Tighten fasteners to specified torque.
3. Install transmission case to cylinder block tighten bolts to 102 Nm (75 ft. lbs.) torque.
4. Remove engine hoist and transmission holding fixture.
5. Remove C-clamp from torque converter housing. Align flex plate to torque converter and install mounting bolts. Tighten to 75 Nm (55 ft. lbs.).
6. Install transmission inspection cover.
7. Connect exhaust system at manifold.
8. Install starter.
9. Install power steering pump and air conditioning compressor belts.
10. Lower vehicle and connect all vacuum lines.
11. Connect all electrical connections including ground strap.
12. Connect fuel lines and accelerator cable.
13. Install radiator and fan assembly. Reconnect fan motor electrical lead. Reinstall radiator hoses. Fill cooling system.
14. Fill engine crankcase with proper oil to correct level.
15. Install hood.
16. Connect battery.
17. Start engine and run until operating temperature is reached.
18. Adjust transmission or linkage if necessary.