LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Fiat >> 2014 >> 500e >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> TPMS Sensor Programming
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

TPMS Sensor Programming

After a sensor has been replaced, the TPM module automatically learns and stores the sensor IDs after the vehicle has been driven for up to 20 minutes continuously above 15 mph (24 km/h). The learning sequence initiates automatically when the vehicle has been stopped for more than 20 minutes.

NOTE: A new sensor ID can also be programmed directly into the TPM module by using a RKE-TPM Analyzer in conjunction with a Scan Tool. Once the new sensor ID has been programmed, the vehicle will need to be driven above 15 mph until the fault is no longer active (lamp extinguishes) and display is updated (for up to 20 minutes). Using a TPM-RKE Analyzer can take up to a minute to force a transmission from a sensor.
scientia non olet · About LEMON Manuals