LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1990 >> Bronco II 4WD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Diagnostic Procedures >> DISTRIBUTORLESS Ignition System (Dis) - No Start (4.0L) >> Test 4, Check Pip Continuity To EEC
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Test 4, Check Pip Continuity To EEC

Turn key off. Disconnect the ECA. Check resistance between J43 (PIP E) and Pin No. 56 (PIP) of the ECA connector. See Figure . If resistance is less than 5 ohms go to TEST 5. If resistance is more than 5 ohms, service open circuit. Reconnect the ECA and check ECA for fault codes. See TESTS W/CODES article.

scientia non olet · About LEMON Manuals