Control Module Connector Resistance Check
WARNING: This page is about a different car, the 1990 Ford Probe and 1989 Ford Probe. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure ignition is off. Verify ABS control module connector is disconnected. Set VOM on 2 k/ohms scale. Measure and record resistance between each of following connector wire terminals:
- White and Red wires (Left Front Wheel Speed Sensor).
- Yellow and Orange wires (Right Front Wheel Speed Sensor).
- Yellow/Green and Yellow/Black wires (Left Rear Wheel Speed Sensor).
- Green and Black wires (Right Rear Wheel Speed Sensor).
- If ALL resistances are between 800-1200 ohms, go to PINPOINT TEST WSS-5 . If any resistance measurement is not within specification, go to PINPOINT TEST WSS-4 .