Continuity Check
WARNING: This page is about a different car, the 1990 Ford Probe and 1989 Ford Probe. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect ABS fail-safe relay. Set VOM on 20 k/ohm scale. At ABS fail-safe relay, measure and record resistance between terminals "c" and "g". If resistance is greater than 10,000 ohms, go to PINPOINT TEST MMR-6 . If resistance is less than specified, replace ABS fail-safe relay.
CAUTION:
When applying voltage, connect POSITIVE jumper wire to terminal "h" on ABS fail-safe relay.