October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Test 41, Check Saw For Short In EDIS Module

With key off, connect ECA. Set DVOM to 20-volt scale. Push EDIS diagnostic cable SAW button. Start engine, and measure voltage between breakout box pins No. (+) J21 (EDIS diagnostic cable SAW detector) and (-) J7 (BAT -). If voltage is 5-7 volts, SAW is shorted in EDIS module. Replace EDIS module. Remove all test equipment, and reconnect all components. Clear Continuous Memory, and check for fault codes. If voltage is not 5-7 volts, go to next test.