Throttle Position Sensor: Service and Repair

Air Charge & Throttle Position Sensor, Air Bypass Valve:

1. Disconnect the Throttle Position (TP) sensor from the wiring harness.
2. If reinstalling the same TP sensor, mark the position of the TP sensor by scribing a mark on the sensor and throttle body.
3. Remove the TP sensor retaining screws, then remove the TP sensor.
4. Position the throttle position sensor so that the connector is facing forward. Rotate the TP sensor clockwise to align the scribe mark (from step 2).
5. Install the TP sensor retaining screws, tightening to 25-33 lb. in. (2.8-3.8 N-m).
6. Connect the TP sensor electrical connector to the harness.
NOTE: The TP sensor is not adjustable.