KOEO Wiggle Test Procedure
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 1993 Mercury Tracer, 1993 Mercury Topaz, 1993 Mercury Sable, 1993 Mercury Grand Marquis, and 1993 Mercury Cougar. However, it is still accessible from the selected car via links, so may be relevant.
Connect test equipment. See Figure. Turn ignition on, and activate self-test using jumper lead or diagnostic tester. Wait 10 seconds, and then deactivate and reactivate self-test. Wiggle test mode is now activated. Tap, move and wiggle suspect sensor and/or harness area. If a fault is detected, a service code may be stored in memory and indicated at diagnostic tester or scan tester. Retrieve code, and perform appropriate test. See SERVICE CODE-TO-TEST MENUS.