Check Control Switches
To check switches, measure resistance between pins No. 5 and 6 of servo connector while pressing each control button. If any resistance is not as specified, replace faulty switch. See CONTROL SWITCH TESTING table. If all resistances are as specified, go to next step.
CONTROL SWITCH RESISTANCES
| Button Depressed | Ohms |
|---|---|
| COAST | 115-125 |
| OFF | 0-4 |
| RESUME | 2090-2310 |
| SET/ACCEL | 645-715 |
NOTE:
In step next step, do not substitute chassis ground for pin No 10.