Steering Control Module: Service and Repair

VAPS Module

The VAPS module is located below the dash panel on the RH side of the steering column tube (3514).

Removal
1. Disconnect wiring harness connector from VAPS module.
2. Remove three module fixture retaining screws from column tube mounting fixture and remove module.

Installation
1. Align mounting holes of new module to mounting holes on column tube mounting fixture.
2. Install three module fixture retaining screws and tighten to 4-5 Nm (35-45 In Lbs.).
3. Reconnect wiring harness connector to VAPS module.