4-Cylinder Ignition Timing

NOTE: Ignition timing is not adjustable on models with distributorless ignition systems.

Ensure engine is at operating temperature, all accessories are off, and transmission is in Park or Neutral. Set parking brake. Ensure idle speed is correct.
Connect timing light to No. 1 spark plug wire. Use jumper wire to connect Data Link Connector (DLC) STI terminal to GND terminal. See Fig 1 . Start engine. Check base ignition timing. See 4-CYLINDER BASE IGNITION TIMING table.
If timing is not to specification, loosen distributor hold-down bolt. Adjust timing as necessary. Turn engine off. Remove jumper wire from DLC terminals. Start engine. Ensure advance mechanism is functioning correctly.

Fig 1: Identifying DLC Terminals

Courtesy of FORD MOTOR CO.

4-CYLINDER BASE IGNITION TIMING

Application

Degrees BTDC @ Idle

1.8L

⁽¹⁾ 9-11

⁽¹⁾	With STI terminal of DLC grounded.