Removal (Except Probe 2.5L)
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 1994 Mercury Tracer, 1994 Mercury Topaz, 1994 Mercury Sable, 1994 Mercury Grand Marquis, and 1994 Mercury Cougar. However, it is still accessible from the selected car via links, so may be relevant.
- Remove high tension leads and distributor cap. Rotate crankshaft in direction of normal rotation until piston No. 1 is at TDC of compression stroke. Disconnect negative battery cable.
- Ensure timing marks are aligned. Disconnect distributor wiring from harness. Mark distributor rotor-to-housing and housing-to-engine position for installation reference. Remove distributor hold-down bolt(s) and clamp. Some engines may be equipped with a security-type distributor hold-down bolt.
- If necessary, use Distributor Hold-Down Wrench (T82L-12270-A) to remove bolt. Remove distributor. Inspect distributor "O" ring and replace if necessary.