LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1995 >> Probe Base, Standard >> Repair and Diagnosis (Single Page) >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - Remove/Install/Overhaul - 2.5L) >> Ignition System >> Distributor Removal & Installation >> Removal & Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect negative battery cable. Remove fresh air duct nuts/bolts. Loosen spring clamp and slide air cleaner assembly forward. Remove fresh air duct. Disconnect distributor connectors. Remove distributor cap and gasket. Disconnect air duct from Volume Airflow (VAF) meter. Disconnect VAF meter connector.
  2. Remove fuel pressure regulator control solenoid from air cleaner, and position solenoid out of way. Remove air cleaner assembly. Remove 2 distributor hold-down bolts and distributor. To install, reverse removal procedure. Set base ignition timing. See the ADJUSTMENTS - 2.5L article.
scientia non olet · About LEMON Manuals