Without A/C

Removal

1. Disconnect battery ground cable.

2. Remove instrument panel center finish trim panel.

3. Remove three screws attaching heater control to instrument panel.

4. Pull the heater control far enough rearward to allow removal of electrical connectors. Remove connectors.

5. Remove A/C plenum vacuum harness from mode selector valve.

6. Remove heater temperature cable.

7. Remove heater control.


Installation

1. Pull the heater temperature cable through the opening in the instrument panel.

2. Attach heater temperature cable into control bracket.

3. Connect A/C plenum vacuum harness to mode selector valve.

4. Install wire harness electrical connectors to the heater control.

5. Position heater control to instrument panel and install three attaching screws.

6. Install instrument panel center finish trim panel.

7. Connect battery ground cable.

8. Check controls for proper operation.