CMP Synchronizer: Installation

Install Synchro Positioner (T96T-12200-A) on synchronizer housing. See Fig 1 . Rotate synchronizer shaft until vane on shaft aligns with slot on synchro positioner. Rotate synchro positioner until engaged into notch in housing. Transfer oil pump intermediate shaft from old camshaft position sensor housing to replacement camshaft position sensor housing.

Fig 1: Installing Synchro Positioner On Synchronizer Assembly (Typical)
Courtesy of FORD MOTOR CO.

Fig 2: Installing CMP Synchronizer
Courtesy of FORD MOTOR CO.
Locate sychronizer in engine so that when sychronizer is fully installed, the sychro positioner points 54 degrees off crankshaft centerline. See Fig 2 .
Install hold-down clamp and tighten bolt to specification. See TORQUE SPECIFICATIONS . Remove sychronizer positioner and install CMP sensor to synchronizer and tighten to specification. Reconnect wiring to CMP sensor. Connect negative battery cable.