LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1997 >> Probe Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Starter) >> On-Vehicle Testing >> Starter Load Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Starter Load Test

WARNING: This page is about a different car, the 1997 Lincoln Mark VIII. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect starter load tester and voltmeter to battery terminals. Ensure no current is flowing through the ammeter and carbon pile of tester. Disconnect terminal "S" of starter relay. See Fig 1 .
  2. Connect remote starter switch between terminal "S" and positive battery terminal. Ensure transmission is in Park on A/T models, or Neutral on M/T models.
  3. Crank engine with ignition off. Note voltmeter indication, then stop cranking engine. Adjust carbon pile to match voltage obtained while cranking. Read ammeter. Replace or repair starter if current exceeds specification. See STARTER SPECIFICATIONS  .
Fig 1: Identifying Starter Solenoid Terminals
G94E32205Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals