Remote Transmitter
NOTE:
For additional information on remote transmitter programming and trouble shooting, see REMOTE KEYLESS ENTRY DIAGNOSTIC SERVICE TIPS
bulletin (Ford Bulletin No. 97-24-13) in TSB.
NOTE:
NGS tester and a Ford Service Function (FSF) card must be used to program remote transmitters. Up to 4 transmitters may be programmed at one time.
To program (or re-program) transmitter(s) into the remote/keyless entry module, perform the following steps:
- Choose SERVICE BAY FUNCTIONS from the Ford Service Function card. Choose DRIVER DOOR MODULE (DDM). Then choose KEY FOB PROGRAMMING.
- Press any button on remote transmitter. Choose FOB 1, 2, 3 or 4 and press STORE. Repeat this procedure for additional transmitters.
- Press CANCEL to get out of programming menu. Note that CANCEL may have to be pressed twice to get of programming menu. Check operation.