Fuel Line Connector: Disconnecting
WARNING: This page is about a different variant/trim than selected.
- Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Using Spring Lock Coupling Remover (D87L-9280-B for 1/2" or T83P-19623-C for 5/8"), remove retaining clip from coupling. Place remover over coupling so protrusion is positioned on cage opening side of coupling. See Fig 1 .
- Close remover over coupling. Push remover into cage opening to release female fitting from garter spring. Separate male and female halves of coupling. Remove tool from disconnected spring lock coupling.