Specifications Index
EXPLORER & MOUNTAINEER SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning - Automatic System | |||
| Service | A/C SYSTEM SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Air Conditioning - Manual System | |||
| Service | A/C SYSTEM SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | 184 Ft. Lbs. (249 N.m) NOTE: Install NEW nut! |
||
| Brakes | |||
| Bleeding Sequence | BLEEDING SEQUENCE | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Drum Brakes | DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | ON-VEHICLE TESTING | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 13-18 psi (89-124 kPa) | ||
| Thermostat R & I | |||
| 4.0L V6 (VIN E) | THERMOSTAT (EXCEPT 2001 SPORT & SPORT TRAC) | ||
| Water Pump R & I | |||
| 4.0L V6 (VIN E) | WATER PUMP | ||
| 4.0L V6 (VIN X) | WATER PUMP | ||
| 5.0L V8 (VIN P) | WATER PUMP | ||
| Engine Mechanical | |||
| 4.0L V6 (VIN E) | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | Minimum 15 psi (103 kPa) at 2000 RPM with engine at normal operating temperature. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 4.0L V6 (VIN X) | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | Minimum 15 psi (103 kPa) at 2000 RPM with engine at normal operating temperature. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 5.0L V8 (VIN P) | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | 40-60 psi (275-413 kPa) at 2000 RPM with engine at normal operating temperature. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab.From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button | ||
| Flywheel/Flex Plate Torque | |||
| 4.0L V6 (VIN X) | Step 1: Tighten to 19-25 Ft. Lbs. (25-35 N.m) Step 2: Rotate 90° |
||
| 4.0L V6 (VIN E) | Step 1: Tighten to 10 Ft. Lbs. (13 N.m) Step 2: Tighten to 52 Ft. Lbs. (71 N.m) |
||
| 5.0L V8 (VIN P) | 75-85 Ft. Lbs. (102-115 N.m) | ||
| Fuel System | |||
| Fuel Filter Location | Under vehicle forward of fuel tank, mounted in clip. | ||
| 4.0L V6 (VIN E) | |||
| Pressure Release Procedure | FUEL PRESSURE RELEASE | ||
| Pressure Specification (KOEO) | 30-45 psi (2.1-3.2 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE | ||
| 4.0L V6 (VIN X) | |||
| Pressure Release Procedure | FUEL PRESSURE RELEASE | ||
| Pressure Specification (KOEO) | 30-45 psi (2.1-3.2 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE | ||
| 5.0L V8 (VIN P) | |||
| Pressure Release Procedure | FUEL PRESSURE RELEASE | ||
| Pressure Specification (KOEO) | 30-45 psi (2.1-3.2 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE | ||
| Fuel Filter R & I | FUEL FILTER | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE (4.0L) HIGH TENSION WIRE RESISTANCE (5.0L) |
||
| Ignition Wires (Routing) | HIGH TENSION WIRE RESISTANCE (4.0L) FIRING ORDER & TIMING MARKS (5.0L) |
||
| Spark Plugs | |||
| Type | |||
| 4.0L V6 (VIN E & VIN X) | RH Original spark plug: Motorcraft AGRF-22PG LH Original spark plug: Motorcraft AGRF-22P Service spark plug: Motorcraft AGSF-22PP |
||
| 5.0L V8 (VIN P) | RH Original spark plug: Motorcraft AWSF-32EG LH Original spark plug: Motorcraft AWSF-32E Service spark plug: Motorcraft AWSF-32EE |
||
| Gap | .052-.056 In. (1.32-1.42 mm) | ||
| Torque | |||
| 4.0L V6 (VIN X) | 7-15 Ft. Lbs. (9-20 N.m) | ||
| 4.0L V6 (VIN E) & 5.0L V8 (VIN P) | 15 Ft. Lbs. (20 N.m) | ||
| Starting | |||
| Starter | STARTER MOTOR SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 100 Ft. Lbs. (135 N.m) WARNING: Failure to retighten wheel lug nuts at 500 miles after installation, may result in wheel coming loose and loss of vehicle control. |
||