Test C: One-Touch Down Feature Inoperative

Check Power Supply To One-Touch Module - Remove driver's door trim panel. Access module located in driver's door. Turn ignition switch to RUN position. Check for voltage on Pink or Light Blue/Black wire at one-touch down module connector. If battery voltage is present, go to next step. If battery voltage does not exist, repair open in Pink or Light Blue/Black wire between instrument panel fuse block and one-touch down module. Retest system operation.
Check One-Touch Down Module Ground Circuit - Using an ohmmeter, check resistance between ground and Black wire at one-touch down module connector. If resistance is 5 ohms or less, go to next step. If resistance is more than 5 ohms, repair open in Black wire. Retest system operation.
Check One-Touch Module Switch Sense - Press and hold master window switch left door window in DOWN position. If left door window glass goes down, replace one-touch down module and retest system operation. If left door window glass does not go down, go to TEST B: SINGLE POWER WINDOW INOPERATIVE .