Specifications Index
WINDSTAR SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | A/C SYSTEM SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | 157-212 Ft. Lbs. (213-287 N.m) | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Drum Brakes | DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | GENERATOR SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | (16 Lbs. + 2 Lbs) -1 Lb. | ||
| Water Pump R & I | |||
| 3.0 L VIN U | WATER PUMP | ||
| 3.8 L VIN 4 | WATER PUMP | ||
| Engine Mechanical | |||
| 3.0 L VIN U | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure (HOT 2500 RPM) | 40-60 psi (276-414 kPa) | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 3.8 L VIN 4 | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure (HOT 2500 RPM) | 40-60 psi (276-414 kPa) | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab.From within Manager or service Writer, click the "30/60/90 Interval or "Maint." button | ||
| Flywheel/Flex Plate Torque | |||
| 3.0 L VIN U | 54-64 Ft. Lbs. (73-87 N.m) | ||
| 3.8 L VIN 4 | 54-64 Ft. Lbs. (73-87 N.m) IMPORTANT: Apply thread sealant to bolt threads. |
||
| Fuel System | |||
| Fuel Filter Location | Under vehicle along frame rail ahead of fuel tank, mounted in bracket. | ||
| Fuel Filter R & I | FUEL FILTER | ||
| 3.0 L VIN U | |||
| Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | ||
| Pressure Specification (KOEO) | 37-43 psi (255-277 kPa) | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE | ||
| 3.8 L VIN 4 | |||
| Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | ||
| Pressure Specification (KOEO) | 37-43 psi (255-277 kPa) | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE | ||
| Ignition | |||
| 3.0 L VIN U | |||
| Firing Order & Cylinder Identification | FIRING ORDER & TIMING MARKS | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER & TIMING MARKS | ||
| 3.8 L VIN 4 | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER & TIMING MARKS | ||
| Spark Plugs | |||
| 3.0 L VIN U | |||
| Type | AWSF-32PP Note: Three different styles of platinum-enhanced spark plugs are produced for the 3.0L engine. Each spark plug has a different part number and use. AWSF-32P spark plugs have a platinum-enhanced center electrode and are used in cylinders 4, 5 and 6. AWSF-32-PG spark plugs have a platinum-enhanced ground (side) electrode and are used in cylinders 1, 2 and 3. If any spark plug is removed and reinstalled, it MUST be installed in the same cylinder from which it was removed. If any spark plug is replaced, use only spark plugs with a part number AWSF-32PP as listed on the Vehicle Emission Control Information (VECI) label. This replacement spark plug has double-platinum enhancement on both the center and ground electrode and may be used in all six cylinders. |
||
| Gap | .042-.046 In. (1.07-1.17 mm) | ||
| Torque | 80-177 Lb-In (9-20 N.m) | ||
| 3.8 L VIN 4 | |||
| Type | AWSF-42EE Note: Three different styles of platinum-enhanced spark plugs are produced for the 3.8L engine. Each spark plug has a different part number and use. AWSF-42E spark plugs have a platinum-enhanced center electrode and are used in cylinders 4, 5 and 6. AWSF-42EG spark plugs have a platinum-enhanced ground (side) electrode and are used in cylinders 1, 2 and 3. If any spark plug is removed and re-installed, it MUST be installed in the same cylinder from which it was removed. If any spark plug is replaced, use only spark plugs with part number AWSF-42EE as listed on the Vehicle Emission Control Information label. This replacement spark plug has double-platinum enhancement on both the center and ground electrode and may be used in all six cylinders. |
||
| Gap | .052-.056 In. (1.3-1.4 mm) | ||
| Torque | 80-177 Lb-In (9-20 N.m) | ||
| Starting | |||
| Starter | STARTER MOTOR SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 85-104 Ft. Lbs. (115-142 N.m) | ||