Specifications Index
CROWN VICTORIA & GRAND MARQUIS SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning - Automatic System | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Air Conditioning - Manual System | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Drum Brakes | DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | GENERAL SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 16 psi (110 kPa) | ||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | Normal oil pressure is 20-45 psi (138-310 kPa) at 1500 RPM. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab.From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button | ||
| Flywheel/Flex Plate Torque | 54-64 Ft. Lbs. (73-87 N.m) | ||
| Fuel System | |||
| Fuel Filter Location | Under vehicle forward from fuel tank on right side, mounted in worm clamp. | ||
| Pressure Release Procedure | FUEL PRESSURE RELEASE & FUEL LINE CONNECTIONS | ||
| Pressure Specification (KOEO) | 35-45 psi (240-310 kPa) | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE | ||
| Fuel Filter R & I | REMOVAL & INSTALLATION (CROWN VICTORIA & GRAND MARQUIS) | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER & TIMING MARKS | ||
| Spark Plug | |||
| Type | Motorcraft AWSF-32P | ||
| Gap | 0.052-0.056 In. (1.32-1.42 mm) | ||
| Torque | 15 Ft. Lbs. (20 N.m) | ||
| Starting | |||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque Specifications | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 85-105 Ft. Lbs. (115-142 N.m) | ||