Specifications Index
EXPEDITION & NAVIGATOR SPECIFICATIONS INDEX
| System | Specifications/Procedure | ||
|---|---|---|---|
| Air Conditioning - Automatic System | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Air Conditioning - Manual System | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | 188-254 Ft . Lbs. (255-345 N.m) | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING SEQUENCE | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Drum Brakes | DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | GENERAL SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 16 psi (110 kPa) | ||
| Thermostat R & I | |||
| 5.4 L V8 (2V) | THERMOSTAT | ||
| Water Pump R & I | |||
| 4.6 L V8 | WATER PUMP | ||
| 5.4 L V8 (2V) | WATER PUMP | ||
| 5.4 L V8 (4V) | WATER PUMP | ||
| Engine Mechanical | |||
| 4.6 L V8 | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | With engine at normal operating temperature, normal oil pressure is 20-45 psi (138-310 kPa) at 1500 RPM. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 5.4 L V8 (2V) | |||
| Compression | ENGINE SPECIFICATIONS | ||
| Oil Pressure | (HOT @ 2000 rpm) 40-60 psi (275.8-413.7 kPa) | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 5.4 L V8 (4V) | |||
| Compression | ENGINE COMPRESSION | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab.From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button | ||
| Flywheel/Flex Plate Torque | Step 1: Loosely install all bolts. Step 2: Tighten bolts in a star pattern to 54-64 Ft. Lbs. (73-87 N.m) |
||
| Fuel System | |||
| Fuel Filter Location | Under vehicle along frame on left side, mounted in worm clamp. | ||
| Pressure Release Procedure | |||
| 4.6 L V8 | FUEL PRESSURE RELEASE & FUEL LINE CONNECTIONS | ||
| 5.4 L V8 (2V) | FUEL PRESSURE RELEASE & FUEL LINE CONNECTIONS | ||
| 5.4 L V8 (4V) | FUEL PRESSURE RELEASE & FUEL LINE CONNECTIONS | ||
| Pressure Specification KOEO | 35-45 psi (242-310 kPa) | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE | ||
| Fuel Filter R & I | FUEL FILTER REMOVAL & INSTALLATION - EXPEDITION & NAVIGATOR | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER & TIMING MARKS | ||
| Spark Plugs | |||
| 4.6 L V8 | |||
| Type | RH Original spark plug: Motorcraft No. AWSF-32PG LH Original spark plug: Motorcraft No. AWSF-32P Replacement spark plug: Motorcraft No. AWSF-32PP NOTE: If a spark plug is removed for examination, it must be reinstalled in the same cylinder. If a new spark plug needs to be installed, use only spark plugs with the base part number suffix "PP" as shown on the engine decal. |
||
| Gap | .052-.056 In. (1.32-1.42 mm) | ||
| Torque | 15 Ft. Lbs. (20 N.m) | ||
| 5.4 L V8 (2V) | |||
| Type | Motorcraft No. AWSF-22E | ||
| Gap | .052-.056 In. (1.32-1.42 mm) | ||
| Torque | 15 Ft. Lbs. (20 N.m) | ||
| 5.4 L V8 (4V) | |||
| Type | Motorcraft No. AWSF-32P | ||
| Gap | .052-.056 In. (1.32-1.42 mm) | ||
| Torque | 15 Ft. Lbs. (20 N.m) | ||
| Starting | |||
| Starter | STARTER MOTOR | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 83-112 Ft. Lbs. (113-153 N.m) | ||