LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft Systems - Passive >> Programming >> Erase All Keys & Program 2 Keys
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Erase All Keys & Program 2 Keys

NOTE: This procedure is to be used when a customer needs keys programmed into system and does not have 2 programmed ignition keys. This procedure is also used when a new ignition switch has been installed. After 2 ignition keys are programmed, see PROGRAMMING USING 2 PROGRAMMED KEYS  to program any additional keys.
CAUTION: This procedure will erase all programmed ignition keys from vehicles memory and vehicle will not start until at least 2 ignition keys have been programmed.
  1. Ensure 2 PATS key are available and both operate ignition switch. Turn ignition switch to START position. Connect NGS tester to Data Link Connector (DLC). Install Ford Service Function (FSF) card in NGS tester. Follow service access procedure to obtain security access. See SECURITY ACCESS  .
  2. Select IGNITION KEY CODE ERASE on NGS tester. Place ignition switch in RUN position and disconnect NGS tester. Turn ignition switch to OFF position. Install first key to be programmed in ignition switch. Turn ignition switch to RUN position for 3 seconds then back to OFF position and remove key. Within 5 seconds insert second ignition key to be programmed into ignition switch and turn ignition switch to RUN position for 3 second. Turn ignition switch to OFF position and remove key. Vehicle should now start with both these keys. If any additional key are to be programmed, see PROGRAMMING USING 2 PROGRAMMED KEYS  .
scientia non olet · About LEMON Manuals