LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Front Suspension System) >> Disassembly And Assembly >> Strut and Spring Assembly >> Disassembly and Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Disassembly and Assembly

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Always wear safety goggles when using a spring compressor. Failure to follow these instructions may result in personal injury.
    NOTE: Do not use an impact wrench on the nut.
  1. Mount the strut and spring assembly in a suitable spring compressor.
  2. Compress the coil spring enough to relieve the tension on the strut assembly.
  3. Remove the strut piston rod-to-bushing nut.
    • To assemble, tighten to 103 Nm (76 lb-ft).
  4. Remove the strut.
  5. Remove the lower coil spring insulator.
  6. Remove the coil spring.
  7. Remove the upper coil spring insulator.
    8. NOTE: During assembly, assemble the bearing plate to the strut so the arrow on the bearing plate points to the outboard side of the vehicle when the strut is installed.
  8. Remove the bearing plate.
  9. Remove the bearing.
  10. Remove the strut upper bushing.
  11. Remove the dust boot and the bumper.
  12. To assemble, reverse the disassembly procedure.
scientia non olet · About LEMON Manuals