Passenger Air Bag Module: Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Install the passenger air bag module trim cover into the instrument panel.
- With the alignment pins positioned to the instrument panel, push in, seating the top (shown) and bottom deployment door retainers.
- Install the 4 passenger air bag module bolts.
- Tighten to 8 N.m (71 lb-in).
- Connect the passenger air bag module electrical connector.
- Close the glove compartment door.
- Repower the system. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
NOTE:
Make sure the J-clips are in place before positioning the passenger air bag module to the instrument panel.