Deactivating/Activating Power Door Unlock Switch Inhibit
WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The power door unlock switch inhibit feature needs to be enabled to perform the deactivating/activating power door unlock switch inhibit procedure.
This is customer configured. Steps 1 through 3 must be completed within 30 seconds.
- Turn the key to the ON position, then press UNLOCK 3 times.
- Turn the key to the OFF position, then press UNLOCK 3 times.
- Turn the key to the ON position and within 5 seconds press LOCK 2 times.
The horn chirps twice to indicate the system is disabled or chirps twice followed by a horn honk to indicate the system is enabled.
Pressing LOCK 2 times again toggles the door lock control switch inhibit feature state.
Turn the key to the OFF position to exit the programming mode.
This feature can also be enabled/disabled using a diagnostic tool.