Programming the Autolock Feature
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The autolock feature is not available on vehicles equipped with a manual transaxle.
NOTE:
The autolock feature can be activated or deactivated independently of the auto-unlock feature.
NOTE:
The autolock feature of the smart junction box (SJB) can also be configured ON or OFF with the diagnostic tool. For additional information on module configuration, refer to
MODULE CONFIGURATION
.
NOTE:
Make sure that the vehicle's perimeter alarm is not armed, the key is in the OFF position and the doors are closed.
NOTE:
When programming the autolock feature using the door lock control switch method the following steps must be carried out within 30 seconds or the procedure will need to be repeated. If the procedure needs to be repeated, wait 30 seconds between programming sessions.
- Turn the ignition key from the OFF to the ON position.
- Press the unlock button on the door lock control 3 times.
- Turn the ignition key from the ON to the OFF position.
- Press the unlock button on the door lock control switch 3 times.
- Turn the ignition key to the ON position. The horn chirps to indicate that programming mode is entered.
- To enable/disable the autolock feature, press the unlock button on the door lock control switch then the lock button. The horn chirps once if the autolocks are disabled or twice (one short chirp followed by a long chirp) if the autolocks are enabled.
- Turn the ignition key to the OFF position. The horn chirps once to signal that the programming is complete.