LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1843 (Information Center) >> General Procedures >> Compass Calibration >> With Message Center
April 5, 2026: LEMON Manuals is launched! Read the announcement.

With Message Center

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: For optimum calibration, drive to an open, level location away from large metallic objects or structures. Switch off all non-essential electrical accessories (rear window defrost, heater A/C, map lamps, wipers, etc.) and make sure all doors are closed.
  1. Start the vehicle.
  2. Locate the compass module at the base of the mirror.
    Fig 1: Locating Compass Module At Base Of Mirror
    GF0004497Courtesy of FORD MOTOR CO.
  3. NOTE: To exit the calibration adjustment mode before carrying out a compass adjustment, press the INFO button.
    Fig 2: Identifying Reset Button
    GF0004498Courtesy of FORD MOTOR CO.
  4. Press and hold the reset button on the LH top of the compass module until RESET FOR ZONE appears in the message center display.
  5. NOTE: The message center display advances automatically to display the CIRCLE SLOWLY TO CALIBRATE message.
  6. Slowly drive the vehicle in a circle no more than 5 times at no more than 5 km/h (3 mph) until CIRCLE SLOWLY TO CAL changes to CALIBRATION COMPLETED in the message center.