Without Message Center

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Compass Calibration Zone Map

Courtesy of FORD MOTOR CO.

NOTE: The compass zone setting is preset from the factory to Zone 8.

Determine which magnetic zone you are in for your geographic location.
Locate the compass module at the base of the mirror.

Fig 2: Locating Compass Module At Base Of Mirror
Courtesy of FORD MOTOR CO.
Turn the ignition key to the ON position.
Press and hold the reset button on the LH top of the compass module until the current setting (1-15) area appears in the instrument cluster integrated display.

Fig 3: Identifying Reset Button
Courtesy of FORD MOTOR CO.
Press the reset button repeatedly to cycle through the zone settings until the correct setting for your geographic location is displayed.
Release pressure on the reset button to exit the zone setting mode. After approximately 5 seconds the display reports the direction and the zone is set.