LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 2047 (Supplemental Inflatable Restraint System) >> Removal And Installation >> Safety Canopy Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Safety Canopy Module: Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new safety canopy module J-nuts.
    2. Fig 1: Safety Canopy Module J-Nuts
    GF0024031Courtesy of FORD MOTOR CO.
    NOTE: If equipped with a moonroof and/or rear window wiper assembly, make sure of correct moonroof drain hose and/or rear window solvent hose routing.
  2. Install the safety canopy rear hook.
    3. Fig 2: Safety Canopy Rear Hook
    GF0024032Courtesy of FORD MOTOR CO.
  3. Hook the safety canopy module to the C-pillar.
    4. Fig 3: Safety Canopy Module Hook At C-Pillar
    GF0024029Courtesy of FORD MOTOR CO.
  4. Install the 2 safety canopy module bolts located near the top of the A- and B-pillars.
    • Tighten to 8 Nm (71 lb-in).
  5. Attach the A-pillar tether pin-type retainer to the A-pillar.
    6. NOTE: If equipped with a moonroof and/or rear window wiper assembly, do not pinch the front moonroof drain hose and/or rear window washer solvent hose.
  6. Install the A-pillar tether bolt.
    • Tighten to 8 Nm (71 lb-in).
  7. Install the 2 safety canopy module bolts near the top of the C-pillar and between the B- and C-pillars.
    • Tighten to 8 Nm (71 lb-in).
  8. Install the 2 bolts to the safety canopy module tether bracket at the C-pillar.
    • Tighten to 8 Nm (71 lb-in).
  9. If the vehicle is equipped with a rear window wiper assembly, position the hose and attach the hose clips.
    10. Fig 4: Hose Clips
    GF0024028Courtesy of FORD MOTOR CO.
  10. If the vehicle is equipped with a moonroof, connect the moonroof rear drain hose.
    11. Fig 5: Moonroof Rear Drain Hose
    GF0024027Courtesy of FORD MOTOR CO.
  11. Connect the safety canopy module electrical connector and attach the connector to the D-pillar.
    12. Fig 6: Passenger Side Safety Canopy Module Electrical Connector
    GF0023983Courtesy of FORD MOTOR CO.
  12. Install the safety canopy module wiring clip to the roof panel brace.
    13. Fig 7: Safety Canopy Module Wiring Clip
    GF0024026Courtesy of FORD MOTOR CO.
  13. Install the remaining 2 safety canopy module bolts near the ignitor (between the C- and D-pillars).
    • Tighten to 8 Nm (71 lb-in).
  14. Install the headliner. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  15. Repower the system. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
scientia non olet · About LEMON Manuals