Section 53 (Manual A/C-Heater Systems): Specifications

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Vehicle is equipped with Supplemental Inflatable Restraint (SIR) system. When servicing vehicle, use care to avoid accidental air bag deployment. SIR system-related components are located in various locations throughout interior and exterior of vehicle, depending on application. Do not use electrical test equipment on or near these circuits. If necessary, deactivate SIR system before servicing components. See appropriate AIR BAG RESTRAINT SYSTEMS article in RESTRAINTS.

SPECIFICATIONS

Application

Specifications

Compressor Type

Ford FS-10 10-Cyl.

Compressor Belt Tension

⁽¹⁾

Compressor Oil Capacity

⁽²⁾

System Oil Capacity

⁽³⁾ 9 ozs.

Refrigerant (R-134a) Capacity

30 ozs.

System Operating Pressures ⁽⁴⁾

High Side

125-225 psi (8.6-15.5 kg/cm² )

Low Side

24-45 psi (1.7-3.1 kg/cm² )

⁽¹⁾	An automatic drive belt tensioner is used to maintain belt tension.

⁽²⁾

If the amount of oil drained from the old A/C compressor is between 3-5 ounces (85-142 ml), pour the same amount plus 1 ounce (30 ml) of clean PAG Refrigerant Compressor Oil or equivalent into the new A/C compressor. If the amount of oil that was removed from the old A/C compressor is greater than 5 ounces (142 ml), pour the same amount drained of clean PAG Refrigerant Compressor Oil or equivalent into the new A/C compressor. If the amount of oil that was removed from the old A/C compressor is less than 3 ounces (85 ml), pour 3 ounces (85 ml) of clean PAG Refrigerant Compressor Oil or equivalent into the new A/C compressor.

⁽³⁾	Use YN-12c PAG Oil (Part No. F7AZ-19589-DA).

⁽⁴⁾	Specification listed is with engine speed at 1500 RPM and ambient temperature at 80°F (27°C).