Remote Transmitter
NOTE:
After first remote transmitter is programmed, all other remote transmitters will be erased. All remote transmitters must be programmed at the same time. Up to 4 transmitters may be programmed at one time.
- Cycle ignition switch from OFF to RUN positions 4 times within 3 seconds. Locks will lock and unlock to confirm programming mode has been entered. Press any button on remote transmitter.
- If additional remote transmitters are to be programmed, press any button on remaining remote transmitters within 7.5 seconds. To exit programming mode, turn ignition switch to START position or wait 7.5 seconds.