Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

Remove the 3 bolts and position the degas bottle aside.
- To install, tighten the bolts to 10 Nm (89 lb-in).

Fig 1: Locating Coolant Reservoir Bolts

Courtesy of FORD MOTOR CO.

Vehicles equipped with 6.0L engine or Hydro-Boost®

Remove the Air Cleaner (ACL). For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.

All vehicles

Disconnect the ABS module electrical connector.
- Release the lock tab.
- Pull the connector from the module.

Fig 2: Disconnecting ABS Module Electrical Connector

Courtesy of FORD MOTOR CO.

Remove the 4 screws and the ABS module.
- To install, tighten the screws to 5 Nm (44 lb-in).
To install, reverse the removal procedure.
- For vehicles equipped with Roll Stability Control (RSC®), carry out the IVD Initialization sequence. Follow the scan tool directions.