Transmission Range (TR) Sensor: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Position TR sensor on the manual shaft, align the 2 TR sensor bolt holes and install the 2 bolts.
- Tighten to 5 Nm (44 lb-in).
Fig 1: Locating TR Sensor Mounting Bolts
Courtesy of FORD MOTOR CO.
Install the manual control lever and the nut.
- Tighten to 12 Nm (106 lb-in).
Fig 2: Locating Manual Control Lever Mounting Nut
Courtesy of FORD MOTOR CO.
Connect the TR sensor electrical connector.

Fig 3: Locating TR Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Adjust the selector lever cable. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS - FUSION HYBRID, MILAN HYBRID & MKZ HYBRID article. Connect the selector lever cable end.

Fig 4: Locating Selector Lever Cable
Courtesy of FORD MOTOR CO.
Install the underbody cover and 7 screws.

Fig 5: Locating Underbody Cover Mounting Screws

Courtesy of FORD MOTOR CO.