Removal And Installation
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Upload the FDIM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION article.
- Remove the instrument panel upper finish panel by pulling straight back.
- Remove the 4 FDIM screws.
- Remove the FDIM.
- Disconnect the electrical connector.
- To install, reverse the removal procedure.
- Download the configuration information to the FDIM. For additional information, refer to PMI in MODULE CONFIGURATION article.
NOTE:
Module configuration is only required if a new front display interface module (FDIM is being installed.