Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch to the OFF position.
Remove the bolts and position the degas bottle aside.
- To install, tighten to 10 Nm (89 lb-in).

Fig 1: Degas Bottle & Bolts

Courtesy of FORD MOTOR CO.

CAUTION: Make sure both latches are released before removing the electrical connectors or connector damage can occur.

Disconnect the fuel injector control module (FICM) electrical connectors. Position the wiring harness aside.

Fig 2: Fuel Injector Control Module (FICM) Electrical Connectors

Courtesy of FORD MOTOR CO.

Disconnect the bulkhead connector and position aside.
- To install, tighten to 5 Nm (44 lb-in).

Fig 3: Bulkhead Connector

Courtesy of FORD MOTOR CO.

Remove the 4 bolts and the FICM.
- To install, tighten to 13 Nm (10 lb-ft).

Fig 4: Fuel Injector Control Module

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.