LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> ZX2 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1134 (Information Center) >> Diagnostic Tests >> Instrument Cluster (IC), Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AL: DTC U0121 - Lost Communication With Anti-Lock Brake System Control Module (ABS) >> Pinpoint Test Al: DTC U0121 - Lost Communication With Anti-Lock Brake System Control Module (Abs)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pinpoint Test Al: DTC U0121 - Lost Communication With Anti-Lock Brake System Control Module (Abs)

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. AL1 RETRIEVE THE RECORDED DTCs FROM BOTH THE CONTINUOUS AND ON-DEMAND INSTRUMENT CLUSTER (IC) SELF-TESTS 
    • Check for recorded instrument cluster (IC) DTCs from the continuous and on-demand self-tests.
    • Is DTC B1318 recorded? 
    1. YES  : Go to Pinpoint Test AG .
    2. NO  : Go to  AL2.
  2. AL2 RECHECK THE INSTRUMENT CLUSTER (IC) DTCs 
    • Clear the DTCs.
    • Repeat the instrument cluster (IC) self-test.
    • Is DTC U0121 still present? 
    1. YES  : Go to  AL3.
    2. NO  : The system is operating correctly at this time. The DTC may have been set due to high network traffic.
  3. AL3 CHECK THE NETWORK OPERATION 
    • Carry out the network test.
    • Does the ABS module pass the network test? 
    1. YES  : Go to  AL4.
    2. NO  : REFER to MODULE COMMUNICATIONS NETWORK article to diagnose no communication with the ABS module.
  4. AL4 CHECK FOR CORRECT INSTRUMENT CLUSTER (IC) OPERATION 
    • Disconnect the instrument cluster (IC) connector.
    • Check for:
      • corrosion
      • damaged pins
      • pushed-out pins
    • Connect the instrument cluster (IC) connector and make sure it seats correctly.
    • Operate the system and verify the concern is still present.
    • Is the concern still present? 
    1. YES  : INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) . TEST the system for normal operation.
    2. NO  : The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.
scientia non olet · About LEMON Manuals