Driver Door Module (DDM): Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Position the DDM and install the bolt.
- Connect the 3 electrical connectors.
- Install the driver door trim panel. For additional information, preform INTERIOR TRIM & ORNAMENTATION article.
- Download the DDM configuration information from the scan tool. For additional information, preform MODULE CONFIGURATION article.
- Train the tire pressure sensors. For additional information, preform WHEELS & TIRES article.
- Preform the DDM self-test on-demand by clearing DTCs, and then retrieving DTCs to confirm all DTCs have been cleared.
NOTE:
If the DDM was not replaced, this is the last step that is necessary.
NOTE:
When successful, this step provides the calibration necessary for the DDM operation and clears DTC B2477. The clearing of this DTC indicates the calibration data has been successfully downloaded to the new DDM.
NOTE:
The following steps are necessary only if the DDM is being replaced.
NOTE:
When successful, this step clears DTCs B2868, B2869, B2870 and B2871. The clearing of these DTCs indicates the DDM has recognized the tire pressure sensors during the training procedure.
NOTE:
DTC C2780 will not clear if any other DTCs are present in the DDM. When successful, this step will clear the DTC C2780.