LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> ZX2 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1563 (Supplemental Restraint System) >> Removal And Installation >> Restraints Control Module (RCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Restraints Control Module (RCM): Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque. Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
  1. Position the RCM and install the 2 RCM bolts on the RH side.
    • Tighten to 12 Nm (106 lb-in).
  2. Connect the small RCM electrical connector.
  3. Install the RCM bolt on the LH side.
    • Tighten to 12 Nm (106 lb-in).
  4. Make sure the connector position assurance lever is all the way back and in the full release position before attempting to connect the connector.
    5. Fig 1: View Of Connector Position Assurance Lever
    G03989905Courtesy of FORD MOTOR CO.
    NOTE: Putting the large Restraints Control Module (RCM) electrical connector into the RCM on an angle can cause bad electrical connections and damage components.
    NOTE: The RCM has been removed for clarity.
  5. Position the large RCM electrical connector into the RCM.
      NOTE: Do not push the connector to the point where the lever pivots and seats itself. Light pressure is needed to get the connector into position on the Restraints Control Module (RCM), before using the lever to fully seat the connector. Damage to the connector or component may occur.
    • With the large RCM electrical connector uniformly aligned to the RCM, lightly push in until a subtle audible click is heard and slight resistance is felt.
    6. Fig 2: Large RCM Electrical Wiring Connector
    G03903873Courtesy of FORD MOTOR CO.
    NOTE: The RCM has been removed for clarity.
  6. Connect the large RCM electrical connector.
    • Using the connector position assurance lever, pivot it toward the RCM, drawing the connector into the RCM.
      • Make sure the thumb tab is engaged to the retainer on the RCM and is locked in place.
    7. Fig 3: Locating RCM Electrical Connector
    GF0008859Courtesy of FORD MOTOR CO.
  7. Install the insulator on top of the RCM.
  8. Install the ashtray bracket.
    1. Position the ashtray bracket to the instrument panel.
    2. Install the screws.
    9. Fig 4: Identifying Ashtray Bracket And Screws
    GF0018694Courtesy of FORD MOTOR CO.
  9. Install the ashtray.
    • Attach the wire harness and connect the cigarette lighter.
    10. Fig 5: Identifying Ashtray And Tabs
    GF0018695Courtesy of FORD MOTOR CO.
  10. Install the carpet patch.
    11. Fig 6: Identifying Carpet Patch
    GF0013454Courtesy of FORD MOTOR CO.
  11. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
scientia non olet · About LEMON Manuals