LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> ZX2 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1563 (Supplemental Restraint System) >> Removal And Installation >> Restraints Control Module (RCM) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Restraints Control Module (RCM): Removal

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas for deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed whether or not the air bags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.
WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque. Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
NOTE: When installing a new Restraints Control Module (RCM), always make sure the correct RCM is being installed. If an incorrect RCM is installed, erroneous DTCs will result.
NOTE: The air bag warning indicator illuminates when the correct RCM fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
  1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
  2. Remove the carpet patch.
    3. Fig 1: Identifying Carpet Patch
    GF0013454Courtesy of FORD MOTOR CO.
  3. Remove the ashtray.
    1. Release the tabs.
    2. Remove the ashtray.
      • Separate the ashtray, disconnect the cigarette lighter and detach the wire harness from the ashtray.
    4. Fig 2: Identifying Ashtray And Tabs
    GF0013455Courtesy of FORD MOTOR CO.
  4. Position the ashtray bracket aside.
    1. Remove the screws.
    2. Position the ashtray bracket aside to access the RCM.
    5. Fig 3: Identifying Ashtray Bracket And Screws
    GF0018693Courtesy of FORD MOTOR CO.
  5. Remove the insulator from on top of the RCM.
  6. Remove the RCM bolts on the RH side.
  7. Disconnect the large RCM electrical connector.
    1. Pinch the thumb tab and pivot the connector position assurance lever all the way back until it stops.
    2. Pull out and disconnect the RCM electrical connector.
    8. Fig 4: Identifying RCM And Electrical Connector
    GF0013460Courtesy of FORD MOTOR CO.
  8. Disconnect the small RCM connector.
  9. Remove the RCM bolt on the LH side and the RCM.
scientia non olet · About LEMON Manuals