Section 1614 (Electronically Controlled Continuously Variable Transmission (ECVT)): Removal: Transaxle
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- To remove the transaxle, follow the engine removal procedure. For additional information, refer to ENGINE MECHANICAL - 2.5L -- FUSION HYBRID, MILAN HYBRID & MKZ HYBRID article. Before removing the engine and transaxle from the vehicle, remove the drain plug and drain the transmission fluid.
NOTE:
Do not drain the oil when removing the engine to service the transaxle.
NOTE:
Inspect the plug and washer for damage and install a new plug if necessary.
- To install, tighten to 40 Nm (30 lb-ft).