Mirror Control Switch
WARNING: This page is about a different car, the 2002 Lincoln Blackwood. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Vehicles produced after 8/20/01 are late production models and have the power folding mirrors as standard equipment.
Remove mirror control switch. See MIRROR CONTROL SWITCH under REMOVAL & INSTALLATION. Measure resistance between specified terminals while operating switch in appropriate direction. For vehicles produced before 8/20/01, see MIRROR SWITCH TEST (EARLY PRODUCTION) table. See Fig 1. For vehicles produced after 8/20/01, see MIRROR SWITCH TEST (LATE PRODUCTION) table. See Fig 2. Resistance in all tests should be 5 ohms or less. If switch fails any portion of test, replace memory set switch.
MIRROR SWITCH TEST (EARLY PRODUCTION)
| Switch Position | Measure Between | |
|---|---|---|
| Driver's Side Mirror | ||
| Up | 1 & 6, 3 & 4 | |
| Down | 1 & 4, 3 & 6 | |
| Left | 3 & 4, 6 & 7 | |
| Right | 3 & 6, 4 & 7 | |
| Passenger's Side Mirror | ||
| Up | 2 & 6, 3 & 4 | |
| Down | 2 & 4, 3 & 6 | |
| Left | 3 & 4, 5 & 6 | |
| Right | 3 & 6, 4 & 5 | |
MIRROR SWITCH TEST (LATE PRODUCTION)
| Switch Position | Measure Between Terminals No. | |
|---|---|---|
| Driver's Mirror | ||
| Up | 2 & 3, 7 & 10 | |
| Down | 2 & 10, 3 & 7 | |
| Left | 2 & 3, 4 & 7 | |
| Right | 2 & 4, 3 & 7 | |
| Passenger's Mirror | ||
| Up | 2 & 3, 7 & 9 | |
| Down | 2 & 9, 3 & 7 | |
| Left | 2 & 3, 5 & 7 | |
| Right | 2 & 5, 3 & 7 | |
| Power Folding Mirror | ||
| In | 1 & 7, 2 & 6 | |
| Out | 1 & 2, 6 & 7 | |