Anti-Lock Brake System (ABS) Module Diagnostic Trouble Code (DTC) Index

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

ANTI-LOCK BRAKE SYSTEM (ABS) MODULE DIAGNOSTIC TROUBLE CODE (DTC) INDEX

DTC	Description	Source	Action
B1342	ECU is Defective	ABS Module	NOTE: If other DTCs are present, REPAIR them before installing a new component. CLEAR the DTCs. RETRIEVE the DTCs. If DTC B1342 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM (ABS) MODULE . REPEAT the self-test.
B1676	Battery Pack Voltage Out of Range	ABS Module	GO to PINPOINT TEST B .
B2477	Module Configuration Failure	ABS Module	Follow the diagnostic tool directions for the configuration procedure.
B2900	VIN Mismatched	ABS Module	VERIFY that the module has the correct as-built data.
C1095	ABS Hydraulic Pump Motor Circuit Failure	ABS Module	GO to PINPOINT TEST C .
C1145	Wheel Speed Sensor RF Input Circuit Failure	ABS Module	GO to PINPOINT TEST D .
C1155	Wheel Speed Sensor LF Input Circuit Failure	ABS Module	GO to PINPOINT TEST D .
C1165	Wheel Speed Sensor RR Input Circuit Failure	ABS Module	GO to PINPOINT TEST D .
C1175	Wheel Speed Sensor LR Input Circuit Failure	ABS Module	GO to PINPOINT TEST D .
C1233	Wheel Speed Sensor LF Input Signal Missing	ABS Module	GO to PINPOINT TEST E .
C1234	Wheel Speed Sensor RF Input Signal Missing	ABS Module	GO to PINPOINT TEST E .
C1235	Wheel Speed Sensor RR Input Signal Missing	ABS Module	GO to PINPOINT TEST E .
C1236	Wheel Speed Sensor LR Input Signal Missing	ABS Module	GO to PINPOINT TEST E .
U1900	CAN Communication Bus Fault-Receive Error	Network Fault	MODULE COMMUNICATIONS NETWORK .
U2023	Fault Received From External Node	Network Fault	MODULE COMMUNICATIONS NETWORK .
U2050	No Application Present	ABS Module	CONFIGURE the ABS module. REFER to MODULE CONFIGURATION . CLEAR the DTCs. RETRIEVE the DTCs and VERIFY successful module configuration. If DTC U2050 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM (ABS) MODULE . CLEAR the DTC. REPEAT the self-test.
U2051	One or More Calibration Files Missing or Corrupt	ABS Module	CALIBRATE the ABS module, follow the directions on the scan tool. CLEAR the DTCs. CARRY OUT the ABS module self-test. RETRIEVE and RECORD any DTCs. If DTC U2051 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM (ABS) MODULE . CLEAR the DTC. REPEAT the self-test.