Accessing Ford Specific PIDs

WARNING: This page is about a different variant/trim than selected.

Turn ignition switch to OFF position. Ensure test equipment is properly attached. Program scan tool using the following steps:

Select VEHICLE & ENGINE SELECTION menu.
Select NEW VEHICLE, YEAR & MODEL.
Select DIAGNOSTIC DATA LINK.
Select POWERTRAIN CONTROL MODULE.
Select PID/DATA MONITOR & RECORD.
Turn ignition switch to ON position or start engine and allow to idle.
Follow operating instructions from scan tool menu.
Select PIDs and press START to begin monitoring. If PID value is not as specified, perform appropriate SYSTEM TEST.